Toro 07324 Installation Instructions Manual page 5

3. Locate the existing bracket mounted to the cross tube
and under the right side of the dash, and remove the
bracket under the dash
Note: Retain the hardware.
G009567
3
2
3
4
3
Right side of the dash shown; 2015 and Before Models Only
1. Bracket (existing)
2. Bolt (existing)
3. Nut (existing)
4. Dash-support bracket
(loose)
4. For 2015 and Before Models only, assemble the new
dash support bracket to the machine by performing
the following procedure:
A. Install the dash bolt (5/16 x 1 inch) through the
right, front support tube, dash, and dash bracket
(Figure 4).
B. Loosely install the flange nut (5/16 inch) to secure
the dash bracket and support tube to the machine
(Figure 4).
C. Loosely install the remaining previously-removed
hardware to secure the dash bracket to the cross
tube and frame
(Figure 4).
3
1
5
7
6
2
Figure 4
5. Right, front support-tube
assembly
6. Dash bolt (5/16 x 1 inch)
7. Flange nut (5/16 inch)
(Figure 4).
5. For 2016 and After Models only, secure the canopy
support to the dash support as follows:
A. Install the spacer and flat washer (11/32 inch)
between the dash and dash support
B. Install the hex-socket button head screw (5/16 x
2 inches) through the canopy support, dash, and
dash support
C. Install the flange nut (5/16 inch) to secure the
dash support to the canopy support
g009567
2016 and After Models Only
1. Hex-socket button head
screw (5/16 x 2 inches)
2. Dash support
3. Flat washer (11/32 inch)
5
(Figure
(Figure 5).
(Figure
Figure 5
4. Spacer
5. Locknut (5/16 inch)
6. Canopy support
5).
5).
g199154