Confirming The Image Of The Return Video Signal In The Viewfinder - Sony Digital betacam DVW-970 Operation Manual

3
Turn the MENU knob to move the
you want to set, and press MENU knob.
b
The mark on the left of the selected item changes to
a z mark, and the z mark on the left of the setting
changes to a ? mark.
4
Turn the MENU knob to select whether or not to
display the selected window, then press the MENU
knob.
The z mark returns to a
returns to a z mark.
5
To continue setting other windows, repeat steps 3 and
4.
6
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
5-2-9 Confirming the Image of the
Return Video Signal in the
Viewfinder
You can set whether or not to see the image of the return
video signal in the viewfinder, using the GENLOCK page
of the MAINTENANCE menu.
Proceed as follows:
1
Set the MENU ON/OFF switch to ON while holding
down the MENU knob.
The TOP menu appears.
2
Turn the MENU knob to move the
"MAINTENANCE," then press the MENU knob.
If this is the first time the MAINTENANCE menu has
been displayed, the CONTENTS page of the
MAINTENANCE menu appears.
If the menu has been used before, the last accessed
page appears.
3
If the CONTENTS page is displayed, turn the MENU
b
knob to move the
the MENU knob to display the GENLOCK page.
If a different page is displayed, turn the MENU knob
until the GENLOCK page appears, then press the
MENU knob to select the page.
The current setting of each item appears on the right of
the item.
86
Status Display on the Viewfinder Screen
b
mark to the item
b
mark, and the ? mark
b
mark to
mark to "GENLOCK," then press
GENLOCK page
M16 GENLOCK
GENLOCK
RETURN VIDEO
GL H PHASE
GL SC PHASE
GL SC 0/180 SEL :
4
Carry out setting operations as follows:
1 Turn the MENU knob to move the
"GENLOCK," and press the MENU knob.
b
The mark on the left of "GENLOCK" changes to
a z mark, and the z mark on the left of the
GENLOCK setting changes to a ? mark.
2 Turn the MENU knob until "OFF" appears, then
press the MENU knob.
The z mark returns to a
returns to a z mark, and the setting is executed.
3 Turn the MENU knob to move the
"RETURN VIDEO," and press the MENU knob.
b
The mark changes to a z mark, and the z mark
changes to a ? mark.
4 Turn the MENU knob until "ON" appears, then
press the MENU knob.
The z mark returns to a
returns to a z mark, and the setting is executed.
5
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
To see the image of the return video signal on the
viewfinder screen
Hold down the RET switch on the lens. The image of the
return video signal input to the GENLOCK IN connector
is displayed on the viewfinder screen while you are
holding down the RET switch.
When the return video function is assigned to the ASSIGN
1 switch, you can see the image of the return video signal
on the viewfinder screen while you are holding down the
ASSIGN 1 switch even if the RETURN VIDEO item is set
to "OFF" on the GENLOCK page of the
MAINTENANCE menu.
Note
When no signal is input to the GENLOCK IN connector,
the image is not changed even if you hold down the RET
switch on the lens.
: ON
: OFF
: 0
: 0
180
b
mark to
b
mark, and the ? mark
b
mark to
b
mark, and the ? mark