Sony Digital betacam DVW-970 Operation Manual page 40

4
When the CONTENTS page is displayed, turn the
MENU knob to move the
MARK then push the MENU knob.
When any page of the MAINTENANCE menu is
displayed, turn the MENU knob until the ESSENCE
MARK or ESSENCE MARK2 page appears, then
push the MENU knob.
ESSENCE MARK page
?M10 ESSENCE MARK
LTC UB-MARKER
REC START MARK
SHOTMARK 1
SHOTMARK 2
SHOT TIME DISP
ESSENCE MARK2 page
?M11 ESSENCE MARK2
OVER AUDIO LIMIT:
GAIN CHG MARK
FILTER CHG MARK :
SHUTTER CHG MARK:
WHITE CHG MARK
FLASH MARK
FLASH MARK LEVEL:
E.MARK SD LINE
The following items on these pages are for setting the
corresponding essence marks:
Mark
REC START MARK To be recorded when recording
SHOT MARK 1/2
OVER AUDIO
LIMIT
GAIN CHG MARK
FILTER CHG
MARK
SHUTTER CHG
MARK
WHITE CHG
MARK
FLASH MARK
You can check whether any of the essence marks that
are automatically recorded (OVER AUDIO LIMIT,
GAIN CHG MARK, FILTER CHG MARK,
SHUTTER CHG MARK, WHITE CHG MARK,
FLASH MARK) has been recorded, by setting the
display for recorded essence marks ON.
40
Recording
b
mark to ESSENCE
: SET
: OFF
: OFF
: OFF
: MD:HM
ON
: ON
ON
ON
: ON
: ON
10
: 17
Condition
starts.
To be recorded when the RET
button on the lens is manually
operated.
To be recorded when the audio
level exceeds 0 dBFS.
To be recorded when the gain
value changes.
To be recorded when the filter is
changed.
To be recorded when the shutter
speed changes.
To be recorded when the white
balance changes.
To be recorded when the
luminance suddenly changes,
such as when the flash is
exposed or the unit is moved
indoors from outdoors.
For details on the display setting, see "5-2 Status
Display on the Viewfinder Screen" (page 77).
5
Turn the MENU knob to move the
to be set.
M10 ESSENCE MARK
LTC UB-MARKER
REC START MARK
SHOTMARK 1
SHOTMARK 2
SHOT TIME DISP
6
Push the MENU knob.
b
mark to the left of the item changes to the z
The
mark, and the z mark to the left of the setting changes
to the ? mark.
7
Turn the MENU knob clockwise or counter clockwise
until the desired setting appears.
To record the mark on tape, select ON.
To not record the mark, select OFF.
Note
Whether or not to record good shot marks (shot mark
1 and shot mark 2) and recording start mark in the
system area is determined by the ON/OFF settings of
the corresponding items regardless of the LTC UB-
MARKER setting on the ESSENCE MARK page.
8
Push the MENU knob.
9
Perform settings for the remaining marks, repeating
steps 5 to 8.
10
When you set FLASH MARK to ON, select the
threshold value (1 to 20) of the luminance level change
for recording the mark.
11
Set the MENU ON/OFF switch to OFF to end the
menu operation.
Settings for recording good shot marks
and recording start mark to the LTC-UBIT
area
Good shot marks (shot mark 1 and shot mark 2) and
recording start mark can also be recorded to the LTC-UBIT
area of tape.
Follow the procedures below:
b
mark to the item
: SET
: OFF
: OFF
: OFF
: MD:HM