Sensor Cover; Maintenance Of The Milk Valve - Miele CVA 6805 Operating And Installation Instructions

Sensor cover

The sensor cover for the cup protection
cut-out is located under the central
spout. If the automatic spout
adjustment sensors do not clearly
recognise a container, this sensor will
stop the central spout.
Clean the sensor cover one a week in
the dishwasher or by hand using hot
water and a little washing-up liquid.
 To remove, press and hold the sensor
cover between the dispensers . The
press the central spout in from both
sides .
This will release the sensor cover.
To replace it:
 Insert both hooks at the back and
press the sensor cover upwards.
Cleaning and care

Maintenance of the milk valve

The milk valve should be cleaned once
a week to ensure good quality milk froth
and prevent sputtering.
Start in the Drinks
 Touch
Main menu
 Select
 Maintenance
the central spout
The central spout and the milk valve will
move into the maintenance position.
You must remove the cleaning
brush before confirming the
message in the display. Otherwise
the coffee machine will be damaged.
 Insert the brush in the milk valve and
move it back and forth.
 Touch
.
OK
The milk valve will move into the correct
position and the milk pipework will be
rinsed through.
menu.
or .
and then Clean
.
OK
65