Table of Contents
Advertisement
Maintenance
3.
Bend the side electrode (Fig. 34) if the gap is not
correct.
2
1
Figure 34
1. Center electrode insulator
2. Side electrode
Installing the Spark Plug
1.
Thread the spark plugs into the spark plug holes.
2.
Tighten the spark plugs to 20 ft-lb (27 N.m).
3.
Push the wires onto the spark plugs (Fig. 33).
4.
Close the hood.
Greasing the Traction Unit
Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1.
Lower the loader arms and stop the engine.
Remove the key.
2.
Clean the grease fittings with a rag.
3.
Connect a grease gun to each fitting
(Fig 35 and 36).
32
3
0.030 in.
(0.76 mm)
m–3215
3. Air gap (not to scale)
s
m–4732
Figure 35
Figure 36
4.
Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
5.
Wipe up any excess grease.
Changing the Fuel Filter
Change the fuel filter after every 200 operating hours
or yearly, whichever occurs first.
Never re–install a dirty filter.
1.
Lower the loader arms, stop the engine, and
remove the key.
2.
Open the hood and remove the left side screen;
refer to Accessing the Engine and Internal
Components, page 23.
3.
Loosen the tank cap to relieve pressure.
m–4056
Advertisement
Table of Contents
