Table of Contents
Advertisement
Maintenance
Closing the Rear Access Cover
1.
Swing the rear access cover to the left and seat it
in place over the back of the traction unit.
2.
Place the latch over the locking bracket
(Fig. 18).
3.
Pull the latch rearward and push it in to lock it in
place (Fig. 18).
Removing a Side Screen
1.
Open the hood.
2.
Pull out and turn the two locking tabs on the
inside of the side screen until they line up with
the slots in the screen (Fig. 19).
1
2
Figure 19
1. Side screen
3.
Slide the screen inward, off of the tabs and pull
it up and out of the engine compartment.
Installing a Side Screen
1.
Slide the screen into the engine compartment
and line up the holes in the bottom of the screen
with the rubber posts in the traction unit frame.
2.
Push the screen firmly down over the rubber
posts.
3.
Slide the slots in the screen over the locking tabs
(Fig. 19).
24
1
m–4738
2. Locking tab
4.
Turn the tabs and fold them down to lock the
screen in place (Fig. 19).
Removing the Front Screen
1.
Open the hood and remove both side screens.
2.
Remove the four bolts securing the front screen
to the traction unit frame and remove the front
screen (Fig. 20).
2
m–4740
Figure 20
1. Front screen
3.
When finished, install the front screen inside the
loader arms with the four bolts removed
previously.
Adjusting the Controls
The factory adjusts the controls before shipping the
traction unit. However, after many hours of use, you
may need to adjust the neutral position of the traction
control, the tracking of the traction control in the full
forward position, and the reverse flow stop of the
auxiliary hydraulics lever.
Adjusting the Traction Control Neutral
Position
If the traction unit creeps forward or backward when
the traction control is in neutral and the unit is warm,
immediately complete the following procedure:
1
2. Bolts (left side bolt not
shown)
Advertisement
Table of Contents
