Table of Contents
Advertisement
Operation
Stopping the Traction Unit
To stop the traction unit, release the traction control,
move the throttle lever to slow (turtle), lower loader
arms to the ground, and stop the engine. Set the
parking brake and remove the key.
POTENTIAL HAZARD
Someone could move or attempt to operate
the traction unit while it is unattended.
WHAT CAN HAPPEN
Children or bystanders may be injured if
they use the traction unit.
HOW TO AVOID THE HAZARD
Always remove the ignition key when
leaving the traction unit, even if just for a
few seconds.
Moving a Non-functioning
Traction Unit
IMPORTANT: Do not tow or pull the traction
unit without first opening the tow valves, or
the hydraulic system will be damaged
1.
Stop the engine.
2.
Open the rear access cover; refer to Opening the
Rear Access Cover, page 23.
3.
Using a wrench, turn the tow valves on the
hydraulic pumps twice counter-clockwise
(Fig. 12).
18
1
m–4767
Figure 12
1. Left tow valve (right track)
4.
Tow the traction unit as required.
5.
When the traction unit has been repaired, close
the tow valves before operating it.
Using the Cylinder Lock
POTENTIAL HAZARD
The loader arms may lower when in the
raised position.
WHAT CAN HAPPEN
Anyone under the loader arms may be
injured or crushed.
HOW TO AVOID THE HAZARD
Always install the cylinder lock when doing
maintenance that requires raised loader
arms.
Installing the Cylinder Lock
1.
Start the engine.
2.
Remove the attachment.
3.
Raise the loader arms to the fully raised position.
4.
Stop the engine.
2
2. Right tow valve (left track)
Advertisement
Table of Contents
