Table of Contents
Advertisement
Operation
5.
Raise the loader arms while tilting back the
mount plate at the same time.
IMPORTANT: The attachment should be
raised enough to clear the ground, and the
mount plate should be tilted all the way back.
6.
Stop the engine.
7.
Engage the quick attach pins, ensuring that they
are fully seated in the mount plate (Fig. 15).
2
1
3
Figure 15
1. Quick attach pins (shown
in engaged position)
2. Disengaged position
3. Engaged position
20
4
m–4056
4. When engaged, the pin
must protrude through the
bottom of the attachment
mount plate.
POTENTIAL HAZARD
If the quick attach pins are not fully seated
through the attachment mount plate, the
attachment could fall off of the traction
unit.
WHAT CAN HAPPEN
Falling attachments can crush you or
bystanders.
HOW TO AVOID THE HAZARD
Always ensure that your quick attach pins
are fully seated in the attachment mount
plate.
Connecting the Hydraulic Hoses
If the attachment requires hydraulics for operation,
connect the hydraulic hoses as follows:
1.
Stop the engine.
2.
Move the auxiliary hydraulics lever forward,
backward, and back to neutral to relieve pressure
at the hydraulic couplers.
3.
Move the auxiliary hydraulics lever into the
detent position.
4.
Remove the protective covers from the hydraulic
couplers on the traction unit.
5.
Ensure that all foreign matter is cleaned from the
hydraulic connectors.
6.
Push the attachment male connector into the
female connector on the traction unit.
Note:
When you connect the attachment male
connector first, you will relieve any
pressure build up in the attachment.
Advertisement
Table of Contents
