Inventory - Grizzly G0720R Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1: (Figures 3 & 4)
A. Assembled Mill ........................................... 1
B. Drill Chuck .................................................. 1
C. Open End Wrench 8/10mm ........................ 1
D. Open End Wrench 14/17mm ...................... 1
E. Open End Wrench 19/22mm ...................... 1
F.
Spindle Lock Pin ........................................ 1
G. Chuck Key .................................................. 1
H. Fuse 1 Amp, Fast-Blow 5 x 20mm ............. 1
I. Fuse 2 Amp, Fast-Blow 5 x 20mm ............. 1
J.
Hex Wrench Set 4, 5, 6, & 12mm ..........1 Ea
K. Bottle for Oil ............................................... 1
A
B
Figure 3. G0720R out of the crate.
-12-
C
D
Qty
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
G
E
F
J
Figure 4. Inventory.
NOTICE
Model G0720R (Mfg. Since 11/10)
H
I
K