Section 5: Accessories - Grizzly G0720R Owner's Manual

ACCESSORIES

SECTION 5: ACCESSORIES

Some aftermarket accessories can be
installed on this machine that could cause
it to function improperly, increasing the risk
of serious personal injury. To minimize this
risk, only install accessories recommended
for this machine by Grizzly.
NOTICE
Refer to the newest copy of the Grizzly
Catalog for other accessories available for
this machine.
H8179—Horizontal Milling Table
Take advantage of the G0720R tilting headstock
feature. Install this lifted cast-iron milling table for
the correct workpiece height when making special
tilted headstock milling operations.
Figure 26. Horizontal milling worktable.
Note: Model G0619 Mill/Drill Shown.
-28-
T10057—Tapping Attachment
Safely use your benchtop milling machine to tap
threads into blind holes. An internal adjustable
clutch mechanism allows you to adjust slip, so if
a tap bottoms in a blind hole before the spindle is
reversed, the clutch slips without the tap shearing
off. You can tap
Maximum speed is 700 RPM.
Note: To use this tapping attachment on the
Model G0720R mill, you must purchase the G1427
R-8/ MT #2 Morse Taper sleeve.
G2861—Face Mill
G4051—Carbide Insert for Face Mill
This 2
(not included). Comes with an R-8 arbor.
H8179
⁄ " to ⁄ " or M5 to M12 threads.
3 1
16 2
Figure 27. T10057 Tapping Attachment.
/ " face mill accepts four carbide inserts
1
2
Figure 28. G2861 Face Mill.
Model G0720R (Mfg. Since 11/10)