Rudder Reference Information; Seatalk Controller Differences - Raymarine SmartPilot X-Series Setup Manual

2

Rudder reference information

In SPX-30, SPX-SOL & SPX-CAN systems, the rudder position is shown by a rudder
reference bar and indicator on the Pilot Controller display.
Note:
The SPX-30 and SPX-SOL systems obtain rudder reference information from a rudder
reference transducer. The SPX-CAN system rudder reference information is provided by the as-
sociated Volvo IPS system.
The basic SPX-10 system is supplied without a rudder reference transducer, so in the
basic system, the Pilot Controller display does not show a rudder reference bar or
indicator. However, the SPX-10 system is compatible with the Raymarine rudder
reference transducer, and this can be fitted as an option.
Display in basic SPX-10 system

SeaTalk Controller differences

Minor differences in the control functions of the ST6002, ST7002 and ST8002
SeaTalk Pilot Controllers are as follows:
ST6002 Controller
• standby & auto
function keys
• +1, -1, +10 & -10 course
change keys
• disp & track extended
function keys
SmartPilot X-Series Commissioning & Setup Guide
ST7002 Controller
• standby & auto
function keys
• +1, -1, +10 & -10 course
change keys
• resp, track, mode, res'm,
disp, up & down extended
function keys
Display in systems with rudder reference
information
ST8002 Controller
• standby & auto
function keys
• Rotary course change con-
trol
• resp, track, mode, res'm,
disp, up & down extended
function keys
D10779-1