Completing The Installation - VeriFone Forecourt Controller Interface Installation Manual

30

Completing the Installation

This section provides instructions for closing up the box, connecting
communications cables between the Forecourt Controller Interface and the
Commander Site Controller, and connecting to the AC power supply.
1. Replace the cover on the enclosure and secure by tightening the two
2. Connect the serial cables with RJ45 connectors (provided with the
3. Route the serial cables to the Commander Site Controller and connect
Caution:
4. Locate the AC power cord provided with the unit.
5. Locate the AC power connector on the end of the FCI enclosure.
thumbscrews.
Commander Site Controller) to the RJ45 ports on the front of the FCI
box.
COM1 COM2
according to the instructions in the Commander Site Controller
documentation.
When installing the cables, make sure they are protected from
damage or accidental disconnection. Route cables along a wall or
under a counter and secure with cable ties or clips. Do not route
cables near sources of possible interference, such as fluorescent
lights, microwaves, intercoms and so forth.
Forecourt Controller Interface Installation Guide
COM3 COM4
AC Power
Connector
August 11, 2016