Adjusting Humidity Level; Warming The H5I; Getting Started; Cleaning And Maintenance - ResMed H5i User Manual

368148 H5i User Guide EUR1 EPN Multi.fm Page 2 Thursday, November 26, 2009 8:52 AM

Adjusting humidity level

Refer to illustration D.
Ranging from OFF to 6, you can adjust the humidity level at any time to find the setting that is most comfortable for you.
To adjust your level of humidity:
1. From your HOME screen, turn
2. Press . The selection is highlighted in orange.
3. Turn until the humidity level that you require is displayed.
4. Press to confirm your choice.

Warming the H5i

The warm-up feature is used to pre-heat the water before starting treatment.
To start warming:
1. Navigate to the humidity level icon.
2. Push and hold
by pressing
Note: In order to assist the heater plate in cooling, your S9 device will continue to blow air for up to an hour after
treatment has stopped. However, you can unplug the device from the power outlet at any time and allow the heater
plate to cool without air flow.

Getting started

1. Make sure your S9 and H5i are connected and the water tub is filled to the maximum water level mark.
2. Adjust the humidification level if required.
3. Fit your mask as described in your mask user guide.
4. To start therapy, simply breathe into the mask and/or press
5. Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
6. To stop treatment at any time, remove your mask and/or press
Notes:
•
If your clinician has enabled SmartStart your device will start automatically when you breathe into the mask and
stop automatically when you remove the mask.
•
Once therapy has started the HUMIDITY LEVEL screen is displayed.

Cleaning and maintenance

Disassembling the H5i
Refer to illustration E.
1. Slide the latch.
2. Lift open the flip lid.
3. Remove the water tub.
4. Discard any excess water from the water tub.
5. Unclip all four side latches.
6. Pull apart the tub lid, plate and base.
Daily:
1. Wash the disassembled tub lid, plate and base in warm water using a mild detergent.
2. Rinse thoroughly in clean water and allow them to dry away from direct sunlight.
2
(Push Dial) until the HUMIDITY LEVEL screen is displayed in blue.
for three seconds. The Warming Up status bar is displayed. You can stop warm-up at any time
for at least three seconds. You can start treatment at any time by pressing
.
.
(Start/Stop).