Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for ResMed H5i
Summary of Contents for ResMed H5i
- Page 1 ™ HEATED HUMIDIFIER Welcome Guide English...
-
Page 3: Travelling Tips
• ClimateLine heated tubing • ClimateLine heated tubing • H5i water tub. Travelling tips When moving or travelling with your H5i: • Ensure that the water tub is empty. • Disconnect the H5i from the S9 by using the release button. English... - Page 4 Setup Align your H5i with your S9 and push them together until they click into place. Connect the DC plug of the power supply unit to the rear of the S9. Connect the power cord to the power supply unit.
-
Page 5: Filling The Water Tub
Remove the water tub. Fill the water tub (through the centre hole) with water up to the maximum water level mark (380 mL). Return the water tub to the H5i. Close the flip lid ensuring that it clicks into place. English... - Page 6 LCD screen Home menu Start/Stop button Starts or stops treatment. Key: Home Humidity level Ramp Setup menu Allows you to Heated tube make changes to settings. Climate Control Info menu Allows you to Start/Stop view your sleep statistics. Push dial Push dial Turning the dial allows you to scroll through...
-
Page 7: Adjusting Humidity Level
LEVEL screen is displayed. orange. displayed in blue. Warming the H5i The warm-up feature is used to pre-heat the water before starting treatment. To start warming: Navigate to the humidity level icon. Push and hold for three seconds. The Warming Up status bar is displayed. -
Page 8: Getting Started
Getting started Make sure your S9 and H5i are connected and the water tub is filled to the maximum water level mark. Adjust the humidification level if required. Fit your mask as described in your mask user guide. To start therapy, simply breathe into the mask and/or press Lie down and arrange the air tubing so that it is free to move if you turn in your sleep. -
Page 9: Cleaning And Maintenance
Cleaning and maintenance You should regularly carry out cleaning and maintenance as described in this section. Disassembling the H5i Slide the latch. Lift open the flip lid. Remove the water tub. Discard any excess water from the water tub. Unclip all four side latches. -
Page 10: Daily Cleaning
Monthly cleaning Peel the flip lid seal from the flip lid and wash it in warm water using a mild detergent. Wipe the exterior of the H5i with a damp cloth and mild detergent. Reassembling the H5i Place the plate back onto the base ensuring that the maximum water level mark faces up. - Page 12 ResMed (UK) Ltd 96 Jubilee Ave Milton Park Abingdon Oxfordshire OX14 4RW UK. See www.resmed.com for other ResMed locations worldwide. For patent information, see www.resmed.com/ip. S9, H5i, ClimateLine are trademarks of ResMed Ltd and are registered in U.S. Patent and Trademark Office. © 2014 ResMed Ltd.