Measurement (Meawa, Meac) - Siemens SINUMERIK 828D Function Manual

Detailed description
2.7 Actions in synchronized actions
2.7.18

Measurement (MEAWA, MEAC)

The following commands can be used in synchronized actions for measurement:
●
●
While the measuring function in the part program is limited to one motion block, the
measuring function can be switched on and off any number of times from synchronized
actions.
Note
Measurement can also be performed in JOG mode via static synchronized actions
References
Detailed information on measuring commands can be found in:
● Coupled motion, curve tables, master value coupling:
● Generic coupling
Measurement tasks and state changes
When a measurement task has been executed from a synchronized action, the control
system responds in the following way:
State
Operating mode change A measurement task activated by a modal synchronized action is not
RESET
Block search
REPOS
End of program
110
(measurement without delete distance-to-go)
MEAWA
(continuous measurement without delete distance-to-go)
MEAC
Programming Manual, Job Planning; Section "Axis couplings"
Description of Functions, Special Functions, Section "Axis couplings (M3)" > "Generic
coupling"
Response
affected by a change in operating mode. It remains active beyond block
limits.
The measurement task is aborted.
Measurement tasks are collected, but not activated until the programmed
condition is fulfilled.
Activated measurement tasks are not affected.
Measurement tasks started from static synchronized actions remain active.
Function Manual, 07/2012, 6FC5397-5BP40-3BA0
.
IDS ...
Synchronized actions