Withdrawing The Enable For The Axis Container Rotation (Axctswec) - Siemens SINUMERIK 828D Function Manual

Detailed description
2.7 Actions in synchronized actions
2.7.15

Withdrawing the enable for the axis container rotation (AXCTSWEC)

Function
Using the command
can be withdrawn again. The command triggers a preprocessing stop with reorganization
(
STOPRE
The following conditions must be fulfilled so that in the channel, the enable signal to rotate
the axis container is withdrawn again:
● In the channel, the axis container rotation must already have been enabled:
● Axis container rotation was still not started:
As feedback signal for the successful withdrawal of the enable signal, the following channel-
specific system variable is reset:
$AC_AXCTSWA[<container>] == 0
For a detailed description of the system variables, refer to:
References:
System Variables Parameter Manual
Syntax
DO AXCTSWEC(<container>)
Meaning
AXCTSWEC
<Container>
100
AXCTSWEC
).
–
AXCTSWE(<container>)
–
$AC_AXCTSWA[<container>] == 1
–
$AN_AXCTSWA[<container>] == 0
: Withdrawing the enable for the axis container rotation for the channel
: Identifier of the axis container
Possible data include:
•
CT<container number>
The number of the axis container is attached to the CT letter
combination. Example:
•
<container name>
Individual name of the axis container set using
MD12750 $MN_AXCT_NAME_TAB. Example:
•
<Axis name>
Axis name of a container axis known in the channel.
an already issued enable signal to rotate the axis container
:
CT3
:
:
A_CONT3
Function Manual, 07/2012, 6FC5397-5BP40-3BA0
Synchronized actions