Soleus Air KY-320 User Manual page 6

water tank float lid should be able to
move up and down freely after correct
installment.
d) Insert the complete water tank back to
the air conditioner unit.
2) Exhaust Duct
When you use the unit as an air conditioner, the hot exhaust air must be directed out of the room.
The exhaust duct is used to allow the hot air out. DO NOT INSTALL OR USE THE EXHAUST
DUCT WHEN THE UNIT IS OPERATED AS A DEHUMIDIFIER OR FAN.
a) Slid exhaust connector all the way down over
the discharge opening of the unit.
b) Mount the external end of the exhaust duct
onto a hole of 5 ¼" (132 mm) on the wall for
optional wall hot air outlet installation, or
c.) Connect the window kit adaptor to the external end of the
exhaust duct for a window or sliding door hot air outlet
installation.
NOTE: In order to increase the efficiency, the exhaust duct should
be keep as short and straight as possible. The exhaust hose can be
cut shorter by unthreading either end of the exhaust duct counter
clockwise. It is not recommended to increase the manufacturer's
length of the exhaust hose. This may impede or damage the unit.
3) Window Kit Installation
a) Open window or sliding door for approximately 5 inches (130 mm)
b) Adjust the length of the window kit to the same length of the window or the sliding door.
Use all three panels if necessary.
c) Use screws to affix the window kit length.
d) Place the window kit to the window or sliding door. Close the window or door as far as
it goes.
e) Mount the window kit extension of the exhaust host onto the window kit.
4
Fig.1 c)
Fig.2 a)
Window,
slidingdoor or
Wall
Fig.2 b)-c)