Central Machinery 63469 Owner's Manual & Safety Instructions page 19

To lubricate the Worm Gear Shaft Assembly
The Worm Gear Shaft Assembly (202S) runs in
an oil bath Gearbox Assembly (201S) and should
not require an oil change more than once a year,
unless the oil becomes contaminated or a leak
occurs due to improper replacement of the Gearbox
Cover. To change oil in the Gearbox Assembly:
1. Position the Saw Arm in the horizontal position.
2. Remove the four Hex Socket Head Screws, Gearbox
Cover, and Gearbox Gasket. (See Figure U.)
3. Remove the old oil from inside the Gearbox
Assembly and replace the oil using 140 weight gear
oil (not included). The new oil should just come to
the edge of the Gearbox (202-1). Do not overfill.
4. Remove the Gearbox Gasket, Gearbox
Cover, and four Hex Socket Head Screws.
(See Figure U and Figure V.)
To Replace The coolant
1. Remove the Hose (78) at the top of the
Coolant Tank (82). Then slide the Coolant
Tank out from under the Stand (77S)
of the Bandsaw. (See Figure W.)
2. Fill the Coolant Tank to about 80% capacity with
a clean, water-soluble coolant (not included).
3. Slide the Coolant Tank back under the Stand
of the Bandsaw. Then re-insert the Hose
through the top of the Coolant Tank.
4. IMPORTANT: Replace the water-soluble coolant
as often as is necessary to keep metal debris
in the coolant from clogging the hoses.
Item 63469 For technical questions, please call 1-888-866-5797.
HEX SOcKET HEAD ScREW
GEARBOX cOVER
&
GEARBOX GASKET
Figure U
GEARBOX ASSy.
Figure V
cOOLANT TANK
Figure W
HOSE
Page 19