Advertisement
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
To Use The Quick Vise
1. Place the workpiece between the Vise Jaws (9, 22)
with the amount to be cut off extending out
past the Saw Blade (251). (See Figure M.)
2. The Bandsaw is equipped with a quick action Vise
Jaw mechanism which allows you to instantly
position the moveable Front Vise Jaw (9).
3. To operate, turn the Hand Wheel (5S)
counterclockwise 1/2 turn and move the Front
Vise Jaw to the desired position. Then tighten
the Front Vise Jaw against the workpiece
by turning the Hand Wheel clockwise.
FRONT VISE JAW
HAND WHEEL
Figure M
4. Setting up the Quick Vise for a straight (0°) cut:
• Loosen the Screws (H) and (G)
of Front Vise Jaw (F).
• Turn the Hand Wheel counterclockwise by half
a turn and slide back the Front Vise Jaw.
• Loosen Screw (A and B) and note that
Screw (A) should be in the slot which
is parallel with the Rear Vise Jaw.
• Rear Vise Jaw at the scale side should be
aligned with the zero (0) on the rule. Tighten
Screws (A and B). (See Figure N.)
• Free "C" slot of casting flush so the vise
can be positioned in all angles.
Page 14
HAND WHEEL
REAR VISE JAW
For technical questions, please call 1-888-866-5797.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
BASE (1)
9
G
H
ORIGINAL pOSITION (FOR 0° cUTTING)
Figure N
5. Setting up the Quick Vise an angle:
• Remove Screws (A and B) from
base of the Rear Vise Jaw.
• Position (D) over (B) and attach the Screw and
Washer (19 and 22) and attach Screw (B).
• Attach Carriage Screw (17) onto Slot (C)
through the curved slot in the Base (1).
• Align edge of the Rear Vise Jaw with
the indexing rule and tighten Screws
at (B and C). (See Figure O.)
THE pOSITION FOR AN ANGLE (45°) cUT.
Figure O
6. Setting up the Quick Vise for
cutting a 12" workpiece:
• Remove both fasteners from the Rear Vise Jaw.
• Position (B) over the outer
threaded hole on the Base.
22
c
A
D
B
J
A
D
B
Item 63469
Hide quick links:
Advertisement
