Advertisement
• Position Slot (A) over the small
rectangular opening across the Base.
• Attach Screws (A and B). Align the lower
edge of the Rear Vise Jaw with the "0" index
mark adjacent to the 16° degree setting.
Tighten the screws. (See Figure P)
To Adjust The Stop Block
For repeated cuts of pre-set lengths:
1. Loosen the Thumb Screw (38) that
holds the Stop Block (41) to the Stock
Stop Rod (40). (See Figure Q)
2. Adjust the Stop Block to the desired length
position. Then re-tighten the Thumb Screw.
To Adjust The Blade Guide Brackets
1. The Blade Guide Knob (261) is adjusted by
loosening the Knob and sliding the Blade Guide
Bracket (269S) up or down to accommodate
the width of the workpiece. (See Figure R.)
2. The Blade Guide Bracket should be set
as close as possible to the workpiece,
without interfering with the workpiece.
3. Retighten the Blade Guide Knob.
Item 63469
For technical questions, please call 1-888-866-5797.
Figure p
WORKpIEcE
INcLUDED)
THUMB
ScREW
STOp
STOcK
BLOcK
STOp ROD
Figure Q
BLADE GUIDE BRAcKET
BLADE GUIDE
KNOB
Figure R
A
D
B
(NOT
Page 15
Hide quick links:
Advertisement
