Chute Crank Adjustment; Rubber Drive Tire Replacement - Snapper EI55224, EI7244 Safety Instructions & Operator's Manual

Section 4 - REPAIR & ADJUSTMENTS
WARNING
Before attempting any adjustments, maintenance,
service, or repairs, stop engine and auger, always
remove key from ignition switch, remove spark plug
wire and secure wire away from spark plug. Before
tilting machine, drain all the fuel from fuel tank.
Allow engine to run, outdoors where fumes can be
safely dissipated, until all fuel is removed from
carburetor.

4.1.9. CHUTE CRANK ADJUSTMENT

1. Loosen adjustment bolt. Move crank worm
bracket away from ring gear slightly. NOTE: The
worm gear should always maintain full contact with
ring gear after adjustment. Retighten adjustment
bolt. If crank still does not operate satisfactorily,
lubricate worm gear and ring gear with grease.
See Figure 4.13.
CHUTE GEAR
RING
ADJUSTMENT
BOLT
FIGURE 4.13
CHUTE
CRANK
ROD
WORM
BRACKET
MOUNTING
BOLT
4.1.10. RUBBER DRIVE DISC REPLACEMENT
1. Tilt machine forward to gain access to drive
system area. Secure machine in the tilted position
to prevent tipping over. Remove drive system cover
plate. See Figure 4.5.
2. Remove the five bolts that secure rubber drive disc
to the drive hub. Remove drive tire. See Figure 4.14.
3. Install new rubber drive disc. Reinstall the five
bolts. Torque to 25 to 40 in. lbs. See Figure 4.14.
RUBBER
DISC
DISC
RETAINER
RETAINING
SCREW(S)
19
CHAIN CASE
ASSEMBLY
FIGURE 4.14