Test Run - Grizzly T28062 Owner's Manual

Inventory
The following is a list of items shipped
with your tool. Before beginning setup, lay
these items out and inventory them.
If any non-proprietary parts are missing
(e.g. a nut or a washer), we will gladly
replace them; or for the sake of expediency,
replacements can be obtained at your
local hardware store.
If you cannot find an item on this
list, carefully check around/inside
the tool and packaging materials.
Often, these items get lost in pack-
aging materials while unpacking or
they are pre-installed at the factory.
Inventory (Figure 2)
A. Mini Rotary Tool .................................1
B. Collets
⁄ ", ⁄ " ............................ 1 Ea.
1 3
8 32
C. Screw Mandrels
D. Diamond Bits
3
—2mm Round ....................................1
—3mm Flame ....................................1
—1mm Cylindrical ..............................1
—2mm Spear .....................................1
E. Steel Burrs
⁄ ":
3
32
—1.5mm Round .................................1
—2mm Cylindrical ..............................1
F. Abrasive Cones:
—Medium ...........................................5
—Coarse ............................................5
G. AC Adapter ........................................1
H. Case (not shown) ...............................1
Model T28062 (Mfd. Since 08/17)
⁄ " ...........................2
3
32
⁄ "
32
A
Figure 2. Inventory.

Test Run

To test run tool:
1. Clear all setup tools away from
machine.
2. Remove knurled collet nut and collet.
3. Connect tool to power supply.
4. Turn ON/OFF/Variable-Speed Control
dial ON and adjust to low RPM. Verify
motor operation.
5. Make sure tool runs smoothly and with-
out unusual problems or noises.
6. Turn ON/OFF/Variable-Speed Control
dial OFF.
B
C
D E
F
G
-7
-