Table 105
describes the fields in
Table 105 Protocol/ Port Report
Label
Protocol/Port
Direction
Amount
Viewing LAN IP address
In the Reports screen, select LAN IP Address from the Report Type drop-down
list to have the Business Secure Router record and display the LAN IP addresses
that the most traffic has been sent to and from and how much traffic has been sent
to and from those IP addresses.
Note: Computers take turns using dynamically assigned LAN IP
addresses. The Business Secure Router continues recording the bytes
sent to or from a LAN IP address when it is assigned to a different
computer.
Figure
Description
This column lists the protocols or service ports for which the most
traffic has gone through the Business Secure Router. The protocols or
service ports are listed in descending order with the most used
protocol or service port listed first.
This column lists the direction of travel of the traffic belonging to each
protocol or service port listed. Incoming refers to traffic that is coming
into the Business Secure Router's LAN from the WAN. Outgoing
refers to traffic that is going out from the Business Secure Router's
LAN to the WAN.
This column lists how much traffic has been sent and received for
each protocol or service port. The measurement unit shown (bytes,
Kilobytes, Megabytes or Gigabytes) varies with the amount of traffic
for the particular protocol or service port. The count starts over at 0 if a
protocol or port passes the bytes count limit (see
page
383).
Nortel Business Secure Router 222 Configuration — Basics
Chapter 20 Logs Screens 381
154.
Table 107 on