Front Panel Operation And Indications - Extron electronics HC 402 Setup Manual

• Alternatively, you can connect an optional 12 VDC, 1.5 A power supply (Extron PS 1215 C) at the transmitter, and
connect an optional 12 VDC, 2 A power supply (Extron PS 1220) at the receiver.
HCT 101 D
Rear Panel
OUT
HCT 101 D
– Return
+12 VDC input
18 watt
Transmitter Power Input
• Connect to optional
12 VDC, 1.5 A power supply.
For both options, connect the external power supply or supplies to a 100 to 240 VAC power source.

Front Panel Operation and Indications

Input Selection and Indication
Input selection button and LED
To select an input from the receiver front panel, push the input 1 button (see
the input connected to receiver input 1.
The corresponding LED lights to indicate that that input is selected (active). If the input is deselected, the LED turns off (is unlit).
Use the auto-switching feature, which is active by default. In the "last connected" auto switch mode, the system automatically
switches to the input where an active AV source device was last connected. If that device is disconnected, the system switches to
the last device connected before that, as long as it has an active signal.
Signal, HDCP, and Audio LEDs
Signal LED — This LED (see figure 2,
input connector. If there is no active signal, the LED is unlit.
HDCP LED —This LED (
corresponding input connector.
HDCP LED State and Indication
On (Lit Steadily)
An HDCP encrypted TMDS signal is detected at the
corresponding input.
HCT 101 D
Top Panel
To
AC
Ridged
power
External Power Supply
Smooth
(12 VDC, 1.5 A max.,
Extron P/N 28-327-57LF)
NOTE: Check the polarity of
each power supply before
connecting it to a unit.
C
) lights to indicate the presence of an active signal at the corresponding
D
) lights to indicate the presence of an active signal with HDCP encryption at the
AV and Communication Only
INPUTS SIG
POWER
12V
1 TP
2.0A MAX
HDMI
– Return
+12 VDC input
24 watt Receiver Power Input
• Connect to optional
12 VDC, 2 A
power supply.
figure
Off (Unlit)
An unencrypted TMDS signal is detected at the
corresponding input or no active TMDS signal is detected.
LINK OUTPUTS COM IR
AUDIO
L R
IN HDMI/CEC Tx Rx G S G 1
To AC power
Ridged
Smooth
• Receiver front panel LED ( ) blinks
during boot-up and remains lit when
the unit is powered and operational.
2, B , on page 2) to select
HCR 102
Rear Panel
DIGITAL I/O
HCR 102
2 G 3 4 G LAN
Ground all devices.
External
Power Supply
(12 VDC, 2 A max.,
Extron P/N 28-284-07LF)
R
HCR 102
Front Panel
1
1
SIGNAL
HDCP
13