Table of Contents
Advertisement
Chapter 4 - Operation
4.10
FDD Parameters (3.3/3.5/3.6 GHz units
only)
The FDD Parameters menu enables viewing/updating the Radio parameters for
Standard operation mode. These parameters do not affect the operation of the unit
when using Advanced Si operation mode. These parameters are provided to
support the Automatic Platform Detection mechanism of the dual-mode CPEs,
allowing pre-configuration of the relevant parameters before switching the sector
to operate in FDD mode using Standard operation mode. These parameters are
applicable only to SUs that may support FDD operation (all SUs in the 3 GHz
bands except the new 3.x GHz Si CPE supporting the entire band from 3.3 to 3.8
GHz).
4.10.1 BST/AU ID
Select this option to define the BST/AU ID. This is the base BST/AU ID used
together with the BST/AU ID Mask to define the range of BSTs/AUs that can
synchronize with the unit.
The BST/AU ID comprises 6 groups of up to 3 digits each, where the range of each
group is 0 to 255. The first 3 groups form the Operator ID. The next 2 groups form
the Cell ID, and the last group forms the Sector ID.
The default BST/AU ID is 186.190.0.0.250.206
4.10.2 BST/AU ID Mask
Select this option to define the BST/AU ID Mask. The BST/AU ID Mask, together
with the BST/AU ID, define the range of BSTs/AUs that can synchronize with the
SU.
The BST/AU ID Mask comprises 6 groups of up to 3 digits each, where the range
of each group is 0 to 255. The first 3 groups form the mask for the Operator ID.
The next 2 groups form the mask for the Cell ID, and the last group forms the
mask for the Sector ID.
The default BST/AU ID Mask is 255.255.255.0.0.0.
4.10.3 Bandwidth
The Bandwidth parameter may not be available in units that support a single
bandwidth. In units where more than one Bandwidth option is available, select
this option to define the bandwidth of the signal.
108
BreezeMAX CPEs Product Manual
Advertisement
Table of Contents
Troubleshooting
