Installation Of Grass Catcher (Slider Type) - Snapper R2167517BV, RP2167517BV, RP215517BVE, WRP216517BE Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.
2.9 INSTALLATION of GRASS CATCHER
(Optional accessory on some models)
ATTACH BAG HOOKS
OVER MIDDLE HANDLE
CROSS BAR
FIGURE 2.14
2.10 INSTALLATION of GRASS CATCHER
(Slide Closure Type)
1. Position grass bag between handles. See
Figure 2.15. Install grass catcher by sliding
connector over flange of adapter. Attach grass
bag hooks over middle handle cross bar. See
Figure 2.16.
LOWER HANDLES
HANDLE
BAG CONNECTOR
FIGURE 2.15
HOOK BAG HANDLE
OVER LOWER
HANDLES
SLIDE CONNECTOR
OVER END OF
ADAPTER FLANGE
MIDDLE
HANDLE
CROSS
BAR
2.11 REMOVING and DUMPING GRASS CATCHER
1. Grasp bag connector and bag handle as shown.
2. First, lift up on bag handle, removing it from the
3. Dump bag by pulling bag slider off of Z-Fold at
4. To close bag, fold rear of bag into Z-shape,
5. Grasp the edge of the Z-fold, and while holding
ADAPTER
FLANGE
10
FIGURE 2.16
See Figure 2.15.
mower handle. Then lift up on bag connector
removing it from the adapter flange.
rear of bag, opening bag.
keeping edges aligned. Note: an illustration of
folding the Z-shape is attached to the bag.
the slider, pull the Z-fold fully into the slider. See
Figure 2.17.
GRASP SLIDER. PULL
Z-FOLD INTO SLIDER
PULL
FIGURE 2.17