Table of Contents
Advertisement
Section 2 - OPERATING INSTRUCTIONS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.
2.6 RECYCLING OPERATION
(Optional accessory on some models)
NOTE: For best recycling results, cut up to a maximum
of 1/3 of grass blade length and recycle ONLY when
grass is dry.
1. Set all wheels in the highest cutting position
(Notch 6).
2. Move engine speed control to "FAST" (Rabbit)
position.
3. Move ground speed control to slowest speed
setting.
4. Proceed mowing slowly. If grass is very dense,
lower each rear wheel latch one notch lower than
the front wheel latches to improve recycling
performance.
2.7 INSTALLATION of GRASS CATCHER – DOOR
BAG
(Optional accessory on some models)
STEP 1: Install the grass bag adapter and secure to
the side and top of the deck with the two nuts
provided on the machine. Slot in front edge of adapter
must be under nut located on top of deck. See Figure
2.9.
SECURE
WITH NUTS
ADAPTER
FIGURE 2.9
SECURE ADAPTER
TO DECK WITH NUTS
9
STEP 2: Install grass catcher by sliding connector
over flange of adapter. Attach grass bag hooks over
middle handle cross bar. See Figure 2.10.
FIGURE 2.10
WARNING
DO NOT operate without entire Grass Catcher or
guard in place. Grass Catcher components are
subject to deterioration during normal use. Inspect
frequently
and
replace
components immediately.
worn
or
damaged
Advertisement
Table of Contents
