Table of Contents
Advertisement
W10000-en.book Page 9 Thursday, October 19, 2006 1:45 PM
Overview
Shipping contents
The projector is shipped with the cables required for connection to a video and PC equipment. Some of the
items may not be available depending on your region of purchase. Please check with your place of purchase.
Some of the accessories may vary from region to region.
Projector
Dust filter
Component Video cable
Remote control batteries
1. To open the battery cover, turn the remote
control over to view its back, push on the
finger grip on the cover and slide it down in
the direction of the arrow as illustrated. The
cover will slide off.
2. Remove any existing batteries (if necessary)
and install two new AAA batteries observing
the battery polarities as indicated in the base of the battery compartment. Positive (+) goes to positive and
negative(-) goes to negative.
3. Refit the cover by aligning it with the case and sliding it back up into position. Stop when it clicks into place.
Notes on handling batteries
• Do not mix old batteries with new ones, or mix different types of batteries.
• Avoid leaving the remote control and batteries in an excessive heat or humid environment like the kitchen,
bathroom, sauna, sunroom, or in a closed car.
• Dispose of used batteries according to the battery manufacturer's instructions and local environment
regulations for your region.
• If the remote control will not be used for an extended period of time, remove the batteries to avoid damage
to the control from possible battery leakage.
2
1
ENTER
Cable panel-connector
Remote
cover
control
US (110V)
EU (220V)
3
C
T
Batteries
User
manual
UK (240V)
Australia
Power cable
Overview
Warranty
card
Japan
9
Advertisement
Table of Contents
