Table of Contents
Advertisement
W10000-en.book Page 32 Thursday, October 19, 2006 1:45 PM
Installing the cable connector-panel cover
The cable connector-panel cover is used to cover those unsightly cables and connections in the rear of the
projector after all of the cable connections have been done.
Important Notice: The following instructions are only for the projector which is intended to be installed
near the floor or in a reachable location. If your projector is ceiling-mounted or out of your reach, it is a
must to install or un-install the cable cover through a qualified technician's help.
To install the cover:
1.
Repeat Step 1~Step 3 in the "To clean the filter:"
section.
See page 31
3.
Turn the projector topside-up. Remove the rear
cover.
5.
Turn the projector over again. Tighten the screws
to hold the cable connector-panel cover and the
projector on both sides.
7.
The installation is finished.
32
Additional information
2.
for details.
4.
6.
Place a soft item on the desk for padding. Turn the
projector upside-down so that you can locate the
screws that hold the rear cover to the projector on
both sides. Loosen the screws.
Manage all the connected cables within the
indentation of the cable connector-panel cover and
attach it to the projector securely.
Re-install the filter cover securely.
Advertisement
Table of Contents
