Nokia N71 User Manual page 90

R1114_en.book Page 90 Friday, September 16, 2005 9:36 AM
Call waiting—If you have activated call waiting (network
service), the network notifies you of a new incoming call
while you have a call in progress. Set the function on
(Activate) or off (Cancel), or check whether the function
is activated (Check status).
Reject call with SMS—Select Yes to send a text message
to a caller informing why you could not answer the call.
See 'Answer or reject a call', p. 57.
Message text—Write a text to be sent in a text message
when you reject a call.
Automatic redial—Select On, and your device makes a
maximum of 10 attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialing,
press .
Summary after call—Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
1-touch dialing—Select On, and the numbers assigned to
the 1-touch dialing keys ( - ) can be dialled by
pressing and holding the key. See also 'Speed dial a phone
number', p. 52.
Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any keypad key, except
, , , and .
Line in use—This setting (network service) is shown only
if the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line. If
you select Line 2 and have not subscribed to this network
service, you will not be able to make calls. When line 2 is
selected, is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change—To prevent line selection (network service),
select Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.
Connection settings
Data connections and access points
Your device supports packet data connections, such as
GPRS in the GSM network. When you use your device in
GSM and UMTS networks, multiple data connections can
be active at the same time, and access points can share a
data connection.
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
90