JLL CT600 PRO Instruction Manual page 13

STEP 5
Attach the pedal bars to the bottom of the swing
arms using an inner hex pan head screw (M8*20),
spring washer (D8), flat washer (D8), plastic bushing
and corrugated washer (D17) on each side.
(All these bolts will be found in the frame)
STEP 6
Attach the pedal bars to the wheel frames using a
hex bolt (M12), flat washer (D12) and nylon nut (M12)
on each side.
STEP 7
Fix the pedals to the pedal bars using four cross pan
head screws (M6*15) on each side.
STEP 8
Connect the sensor wires from the monitor bracket
to the monitor, making sure the pins are aligned and
you hear a click. Then, secure the monitor using four
screws found in the back of the monitor.
Lastly, to power on the machine insert the end of the
power cable into the front of the main base.
13