Ct600 Pro Assembly - JLL CT600 PRO Instruction Manual

CT600 PRO ASSEMBLY

The cross trainer has been assembled and tested at the factory, so you shouldn't have any
problems putting all the parts together. Components are designed to fit together, and
only basic tools are required for the assembly process. Inside the box you will find a Tools
Pack (Hex Allen Key, Spanner, Washers and Bolts). See previous page.
To assemble your JLL CT600 PRO please follow these easy steps:
STEP 1
Start by fixing the main frame to the bottom frame
using four hex socket head bolts (M10*65) and four
flat washers (D10) on the center. Use two hex
socket head bolts (M10*20) and two arc washers
(D10) on the front. (All these bolts will be found in
the bottom frame)
STEP 2
Place the wheels onto the grooves along the
bottom frame and make sure the L shaped piece
fits under the rail.
STEP 3
Attach the wheel covers using two tapping screws
on either side.
STEP 4
Fix the swing bars to the shaft on the main frame
using the bolts found on the end of the shafts.
Then add the hole covers over the top.
12