Advertisement
Setting User Login
Make the settings of Netwk Authentic. of User/Job Account
on the machine.
NOTE:For User Login setting, refer to the Operation Guide
of the machine.
When you enable User Login on the machine, you need to
make the setting of user account for the printer driver in
order to print by the computer. For details, refer to the
Printer Driver User Guide, Device Settings, and
Administrator Settings.
Login
After installing the Card Authentication Kit (B) and setting
User Login, Use ID card to login. will appear when you use
the machine.
To login, hold the ID card over the ID Card Reader.
Caution: Do not attempt to read two ID cards at once.
Key Login
You can login by entering the administrator password and
administrator password without using the ID card.
NOTE: You can make the login permission or prohibition
setting. For the setting procedure, refer to Key Login
setting.
This function can only be used when the administrator logs
in.
Follow the steps below.
1
Press the ► key.
2
Enter the administrator ID using the arrow keys and
then press the OK key.
NOTE:Press the ▲ or ▼ key to increase or decrease,
respectively, the value at the blinking cursor. Enter the
specified ID. Press the ◄ or ► key to move the cursor left
or right. Enter an ID consisting of between 1 and 16
numbers.
3
Enter the administrator password using the arrow keys
and then press the OK key.
NOTE:Press the ▲ or ▼ key to increase or decrease,
respectively, the value at the blinking cursor. Enter the
specified password. Press the ◄ or ► key to move the
cursor left or right. Enter a password consisting of between
0 (no settings) and 16 numbers.
To return to the Use ID card to login. screen, press the
Cancel key.
Logout
After completing the procedure, press the Logout key on
the control panel.
2
Advertisement
