Operation; Start Up; [A] Start Up; [B] Removal Of Front Cover - Hoshizaki IM-30M Instruction Manual

full" indication.
* When the ice level in the Storage Bin decreases and the Bin Control Switch Lever goes
back to the original position, the unit will resume the icemaking process automatically.
* When the Storage Bin fills up, move stored ice to the left side for maximum storage
capacity.
* Ice in the Storage Bin will melt gradually to become less clear and smooth, but will clear
again in drinks.
II. OPERATION

1. START UP

[a] START UP

In case of low water, open the Drain Valve to drain rusty water before starting up
the unit.
1) Open the Water Supply Line Shut-off Valve.
2) Open the Water Supply Valve.
3) Plug the unit into a separate outlet.
4) Remove the Front Cover.
5) Turn on the Power Switch (Earth Leakage Circuit Breaker). The Display will illuminate
the letters "on", and the unit will start the automatic icemaking process in 3 minutes.
6) Replace the Front Cover in its correct position.

[b] REMOVAL OF FRONT COVER

1) Lift up the Front Cover 1 cm and pull
toward you.
2) To replace, fit the notch in the Front
Cover against the tab on the frame, and
pull down.
IMPORTANT
9
Notch
(both sides)
Tab on frame
(both sides)