Table of Contents
Advertisement
Air-Cooled Model
Icemaker Water
Supply Inlet
1/2" FPT
Icemaker
Drain Outlet
3/4" FPT
Bin
Bin Drain Outlet
3/4" FPT
Separate piping to approved
drain. Leave a 5 cm vertical
air gap between the end of
each pipe and the drain.
Water-Cooled Model
Icemaker Water
Supply Inlet 1/2" FPT
Condenser
Drain Outlet
1/2" FPT
Condenser Water
Supply Inlet 1/2"
FPT
Icemaker
Icemaker
Drain Outlet
3/4" FPT
Bin
Bin Drain Outlet
3/4" FPT
Hard Pipe
Separate piping to approved
drain. Leave a 5 cm vertical
air gap between the end of
each pipe and the drain.
Icemaker
Vent Tube
Hard Pipe
5 cm air gap
Floor
Drain
Vent Tube
Hard Pipe
5 cm air gap
Floor
Drain
Fig. 7
Water Supply Tap
Dual Check Valve
Tap Washer
Braided SS Inlet Hose
Tap Washer
3/4" to 1/2" Nipple
To icemaker
Fig. 8
[Connection to the drain]
* Water should drain into an open trap.
* Drain lines should not be piped directly to the sewer system. A vertical
air gap of a minimum of 5 cm should be between the end of the drain
pipes from the icemaker and the floor drain.
* The icemaker drain is gravity flow, so ensure drain pipe has an
adequate pitch or fall. To prevent a backflow into the storage bin, the
outlet hose must be laid as shown below.
GOOD
Downgrade
Fig. 9
* The icemaker drain line must be run separately from the storage bin/
dispenser unit drain line.
II. OPERATING INSTRUCTIONS
1. This icemaker is designed to produce edible ice. To keep the
icemaker hygienic:
* Wash your hands before removing ice. Use the plastic scoop
provided (accessory).
* The storage bin is for ice use only. Do not store anything else
in the bin.
* Clean the storage bin before use (see "III. 1. CLEANING").
* Keep the scoop clean. Clean it by using a neutral cleaner
and rinse thoroughly.
* Close the door after removing ice to prevent entrance of dirt,
dust or insects into the storage bin.
2. All parts are factory-adjusted. Improper adjustments may result
in failure.
3. If the unit is turned off, wait for at least 3 minutes before
restarting the icemaker to prevent damage to the compressor.
1. OPERATION
The installer will normally commission the icemaker to start the automatic
icemaking process. To ensure continuous operation, make sure that:
* The water supply tap is on,
* The icemaker is plugged into the power supply, and
* The control switch is in the "ICE" position.
2. PREPARING THE ICEMAKER FOR LONG STORAGE
1) Move the control switch to the "OFF" position.
2) Unplug the icemaker or disconnect the power supply.
3) Close the water supply tap, and remove the inlet hose.
4) Remove all ice from the storage bin/dispenser, and clean the bin/
dispenser.
5) Ask for draining of the icemaker by professional qualified personnel.
5
ENGLISH
BAD
Upgrade
BAD
WARNING
Advertisement
Table of Contents
