Installing The Junction Box Accessory - Shure MXA910 Manual

Step 2: Masking and Painting
1. Use masking tape to cover the entire extrusion that runs along the inside of the frame. This ensures that the
necessary metal pieces make contact when reassembled.
2. Use masking tape to cover the hook-and-loop fastener strips on the grille.
3. Paint the frame and grille section and allow it to completely dry before reassembling. Do not paint any part of
the main assembly.
(2.1) Masking off the extrusion (highlighted in black)
Step 3: Reassembly
1. Secure the foam piece with the hook-and-loop fastener strips around the edges.
2. Slide the grille back into the frame.
3. Attach the remaining side of the frame and secure it with the 4 screws.
4. Attach the LED lightpipe into the black plastic guide piece.
5. Align the LED with the lightpipe and put the assembly back in place on the frame.
Note: The label on the assembly is placed on the corner that corresponds to the LED. Use it for reference to
ensure proper orientation during reassembly.
6. Install the screws (6 per side) to secure the main assembly to the frame. Do not over-tighten.

Installing the Junction Box Accessory

The A910-JB junction box mounts on the microphone, enabling conduit connections for cable runs. Refer to local
building codes and regulations to determine if the junction box is necessary. There are three punch-out sections on
the junction box for attaching conduit.
Shure Incorporated
31/87