Switch Features - HP Aruba 3810M Series Installation And Getting Started Manual

Table 15 Stacking Module LEDs (continued)
Name
Stacking Link Status

Switch Features

The features of the 3810M switches include:
Combinations of fixed 10/100/1000-T, HPE SMART RATE and SFP/SFP+ ports, as described
under Network
Selected switch models feature HPE SMART RATE ports and provide 1Gbps, 2.5Gbps,
5Gbps and 10Gbs connectivity. See the appendices for cabling recommendations and
requirements.
All switch models feature either 1 or 2 Flex Port Module slots, that allow configuration with
either 10G SFP+ or 40G QSFP+ ports, as described in
One module slot is provided in the back of the switches to support a stacking module to
provide connectivity to other 3810M switches with stacking modules. See
Information and
K/KA/KB.16.01 for more information about stacking.
Power over Ethernet (PoE+) operation—Aruba 3810M 24G PoE+ 1-slot Switch (JL073A),
Aruba 3810M 48G PoE+ 1-slot Switch (JL074A) and Aruba 3810M 40G 8 HPE Smart Rate
PoE+ 1-slot Switch (JL076A) switches are IEEE 802.3at standard compliant and provide up
Function
The Link LED per stacking
port indicates the port is
enabled, connected and
detects a signal from the
attached device.
Ports.
Topologies, the HPE ArubaOS-Switch Advanced Traffic Management Guide
Mode
Fast Flash Orange
Off
On Green
Slow Flash Orange
Off
Flex Port Slot and Module
Description
should be synchronized with
the switch Global Status
LED. The Global Status and
Back LED should also be
flashing.
Stacking module or one or
more of its ports is
experiencing an alert
condition.
Alert conditions include that
an unsupported cable has
been installed in the module
or that the stacking module
has been installed while the
switch was powered on
(hot-swapped) and the
switch needs to be rebooted
to support the module.
The BACK LED should be
flashing and the Global
Status LED should NOT be
flashing.
No Power
The port is enabled and
receiving a link indication
from the connected device.
Port Failed POST or cable
fault. Module Status LED on
the stacking module and
Global Status and Back
LED on front of unit should
also be synchronized and
flashing orange.
No cable plugged in.
Support.
Stacking
Switch Features 25