Management Ports; Console Ports; Auxiliary (Aux) Port; Switch And Port Leds On Front Of The Switches - HP Aruba 3810M Series Installation And Getting Started Manual

Table 5 Optional Network Connectivity, Speeds and Technologies (continued)
40 Gbps
Smart Rate
1/2.5/5/10
Gbps
1
For supported transceivers, visit
In the first textbox, type J4858 (for 100-Mb and Gigabit information), J8436 (for 10-Gigabit information), or JH231
(for 40–Gigabit information).
Select any of the products that display in the dropdown list.
Select Support Center. Then click on Manuals, followed by View All to and find the Transceiver Support
Matrix.
For technical details of cabling and technologies, see

Management Ports

Console Ports

There are two serial console port options on the switch, an RJ-45 or Micro USB. These ports are
used to connect a console to the switch either by using the RJ-45 serial cable supplied with the
switch, or a standard Micro USB cable (not supplied). The Micro USB connector has precedence
for input, so if both cables are plugged in, the console output is echoed to both the RJ and
Micro-USB ports. But, the input is only accepted from the Micro-USB.
For more information on the console connection, see
console" (page
or a VT-100 terminal.

Auxiliary (Aux) Port

An auxiliary port for processing a USB command file or downloading switch software code. This
port uses a USB Type A connector, but does not comply with all USB protocols and standards.

Switch and Port LEDs on Front of the switches

Front of Switch Status and Mode LED Behavior
status LEDs and also the Switch Mode LEDs.
Table 9 (page 15)
Fiber (single
10-Gig ER
mode)
40-Gig Direct Copper
Attach 1/3/5 m (twinaxial)
Fiber
40-Gig SR4
(multimode)
Fiber
40-Gig ESR4
(multimode)
Fiber (single
40-Gig LR4
mode)
Copper
Smart Rate
(twisted pair)
http://www.hpe.com/networking/support .
44). The console can be a PC or workstation running a VT-100 terminal emulator,
describes the switch Port LEDs and their different mode behaviors.
RJ-45
Cabling and Technology Information.
"10. (Optional) Connect a Management
describes the switch chassis and Flex Port
Not Applicable
MPO
MPO
LC
Front of the Switches 11