Kenwood TK-3312 Service Manual page 8

TK-3312/3317
■ Item setting mode flow chart
[1. RX frequency] or
[3. TX frequency]
[S]
MHz setting
[A]
[Selector]
kHz setting
[A]
[Selector]
Channel step
[A]
[Selector]
Frequency clear
[A]
[Selector]
[2. RX signaling] or
[4. TX signaling]
[S]
OFF
[A]
[Selector]
QT
[A]
[Selector]
DQT N
[A]
[Selector]
DQT I
[A]
[Selector]
5. RF power Hi / Low
[S]
Hi / Low selection
[A]:
[S] : Stored
Not
stored
6. Scan Del / Add
[S]
Del / Add selection
[A]:
[S] : Stored
Not
stored
[7. Beat shift on/off] or
[8. Compander on/off]
[S]
on / off selection
[A]:
[S] : Stored
Not
stored
8
REALIGNMENT
Display
Current
490. 00000
setting value
Value is not set
--------
490. 00000
[<B] / [C>] [S]
490. 00000
[<B] / [C>] [S]
STP 5.00K
[<B] / [C>] [S]
--------
[S] : Cleared
[2. RX signaling] or
[4. TX signaling]
OFF
DQT I
Display
[S] : Tone off TONE OFF
QT 67.0
[<B] / [C>] [S]
[<B] / [C>] [S] DQT 023N
DQT 023 I
[<B] / [C>] [S]
[<B] / [C>]
Display
Hi Low 5.PWR HI
[<B] / [C>]
Display
Del Add 6.SCN ADD
[<B] / [C>]
Display
on off 7.SFT ON
8.CMP ON
6. Firmware Version Information Mode
Turn the transceiver ON with the [Side1] and [Side2] keys
held down. Then, the version is displayed during holding the
[Side1] and [Side2] keys.
or