Kenwood TK-7185 Service Manual Addendum page 6

TK-7185
1. Turn the source transceiver power ON with the [B] key
held down. If the read authorization password is set to
the transceiver, the transceiver displays "CLONE LOCK".
If the password is not set, the transceiver displays
"CLONE MODE".
2. When you enter the correct password, and "CLONE
MODE" is displayed, the transceiver can be used as the
cloning source. The following describes how to enter the
password.
3.
• How to enter the password with the microphone keypad;
If you press a key while "CLONE LOCK" is displayed,
the number that was pressed is displayed on the trans-
ceiver. Each press of the key shifts the display in order to
the left. When you enter the password and press the [ ]
key, "CLONE MODE" is displayed if the entered pass-
word is correct. If the password is incorrect, "CLONE
LOCK" is redisplayed.
• How to enter the password with the [ ] and [ ] keys;
If the [ ] and [ ] keys is pressed while "CLONE LOCK"
is displayed, numbers (0 to 9) are displayed flashing.
When you press the [C] key, the currently selected num-
ber is determined. If you press the [S] key after entering
the password in this procedure, "CLONE MODE" is
displayed if the entered password is correct. If the pass-
word is incorrect, "CLONE LOCK" is redisplayed.
4. Power ON the target transceiver.
5. Connect the cloning cable (Part No. E30-3382-05) to the
modular microphone jacks on the source and target.
6. Press the [S] key on the source while the source displays
"CLONE MODE". The data of the source is sent to the
target. While the target is receiving the data, "PRO-
GRAM" is displayed. When cloning of data is completed,
the source displays "END", and the target automatically
operates in the User mode. The target can then be oper-
ated by the same program as the source.
7. The other target can be continuously cloned. When the [S]
key on the source is pressed while the source displays
"END", the source displays "CLONE MODE". Carry out
the operation in step 4 to 6.
Notes:
• Only the same models can be cloned together.
• Cannot be cloned if the overwrite password is pro-
grammed to the target.
Cloning cable
(E30-3382-05)
6
REALIGNMENT
Fig. 2
8. Firmware Version Information
Press and hold the [ ] key while turning the transceiver
power ON and then keep pressing and holding the [ ] key,
the fi rmware version information appears on the LCD.
9. Clock Adjustment Mode
9-1. Flow chart of operation
[C] + Power ON
YEAR
[S]
MONTH
[S]
DAY
[S]
HOUR
[S]
MINUTE
[S]
[ ] and [ ] keys
[ ] and [ ] keys
[ ] and [ ] keys
[ ] and [ ] keys
[ ] and [ ] keys
Completion