Kenwood TK-7185 Service Manual Addendum page 10

TK-7185
■ Connect the KRK-10 main panel to the rear
panel with the cable
8. Insert one 14-pin connector of the cable (E30-7514-15)
into the connector (CN3) of the interface unit (A/2) of the
main panel. ( !1 )
Note: Insert the connector that has a sticker onto the
cable to the connector of the main panel.
5. Voice Guide & Storage Unit (VGS-1: Option)
Note: Because the VGS-1 is a non-RoHS product, it is not
sold in the European market.
5-1. Installing the VGS-1 unit in the transceiver
1. Remove the cabinet, top packing and shielding plate of
the transceiver.
2. Attach two cushions to VGS-1 as shown in Figure 5. ( q )
Note: Be sure not to cover the connector with the bot-
tom cushion.
3. Insert the VGS-1 connector (CN1) into the TX-RX unit (B/3)
connector (CN403). ( w )
Note: You must setup using the KPG-92D.
10
INSTALLATION
CN4
Sticker
KRK-10
rear panel
Fig. 4-5
9. Secure the cable bush on the main panel and fi t the wa-
terproof packing (orange) ( !2 ) securely over top.
10. Install the molded cover ( !3 ) over the connector on the
main panel and secure it with two screws ( !4 ).
11. Insert the other 14-pin connector of the cable into the
connector (CN4) of the interface unit (B/2) of the rear
panel. ( !5 )
12. Secure the cable bush on the rear panel and fi t the wa-
terproof packing (orange) ( !6 ) securely over top.
13. Install the molded cover ( !7 ) over the connector on the
rear panel and secure it with two screws ( !8 ).
Note: A cable can be connected from the left side as shown
in the Figure 4-5 or from right side.
However, the 14-pin connector must be connected to cor-
rect direction.
CN3
(Right side)
Cushion
(G13-1994-04)
20 x 30 x 12 mm
VGS-1
CN1
Cushion
(G13-1992-04)
CN403
21 x 21 x 2.5 mm
Fig. 5
KRK-10
main panel
Sticker