Kenwood TK-7185 Service Manual Addendum page 20

TK-7185
Item Condition
5. Max low 1) Adj item: [MLPWR]
power Adjust: [✳✳✳]
adjust 2) Adj item: [L MLPWR] →
[L' MLPWR] → [C MLPWR]
→ [H' MLPWR]
→ [H MLPWR]
Adjust: [✳✳✳]
PTT: ON
6. High power 1) Adj item: [HPWR]
adjust Adjust: [✳✳✳]
2) Adj item: [L HPWR] →
[L' HPWR] → [C HPWR] →
[H' HPWR] → [H HPWR]
Adjust: [✳✳✳]
PTT: ON
7. High power [Panel test mode]
check 1) CH-Sig: 1-1
PTT: ON
2) CH-Sig: 2-1
PTT: ON
3) CH-Sig: 3-1
PTT: ON
8. Low power 1) Adj item: [LPWR]
adjust Adjust: [✳✳✳]
2) Adj item: [L LPWR] →
[L' LPWR] → [C LPWR] →
[H' LPWR] → [H LPWR]
Adjust: [✳✳✳]
PTT: ON
9. Low power [Panel test mode]
check 1) CH-Sig: 1-1
Set low power (Push [S])
PTT: ON
2) CH-Sig: 2-1
PTT: ON
3) CH-Sig: 3-1
PTT: ON
20
ADJUSTMENT
Measurement
Test-
Unit Terminal Unit
equipment
Power Rear ANT Front
meter panel panel
Power
meter
Ammeter
Front
panel
Adjustment
Parts Method
[ ],[ ] 15W ±1W
CAUTION!
Do not attempt to adjust the
transceiver's transmit output
power beyond its specifi ca-
tions.
If the transceiver is adjusted
beyond the specifi cations, it
may cause deterioration of
the parts reliability and the
output power may be lowered
suddenly and unstable.
The transceiver may be also
extremely hot.
25W ±1W
9A or less
Check 22.5~27.5W
9A or less
[ ],[ ] 5.0W ±0.5W
5A or less
Check 3.5~6.5W
5A or less
Specifi cations / Remarks