Kenwood TK-3148 Service Manual page 37

■ How to assemble the antenna connector and its
terminal.
The antenna connector and its terminal are supplied as
separate parts.
When replacing the antenna connector and/ or terminal,
assemble the parts prior to the replacement.
1. Mount the antenna connector onto the chassis
• Double-sided adhesive tape is attached to the terminal; peel
off the tape cover ➁.
• Attach the terminal to the antenna connector as shown
below.
• Slide the antenna terminal along the adhesive cushion on
the chassis so that the adhesive part on the terminal is
firmly attached to the antenna connector ➂.
2. Remove the antenna connector from the chassis with its
terminal attached, then solder the center part of antenna
connector to its terminal
Do not use excessive solder on terminal.
ADJUSTMENT /
➀.
➃.
TOP /
Bottom
调整
■ 如何组装天线连接器及其端子
天线连接器及其端子是单独提供的部件。 当更换天线连接器
和 / 或端子时，在换上前先将其组装起来。
1. 把天线连接器安装到底盘
在端子上贴上双面胶，揭掉双面胶覆层
•
按下图所示把端子安装到天线连接器上。
•
延底盘上的胶粘垫滑动天线端子， 使端子上的胶粘部分牢固
•
➂
地与天线连接器
2. 把天线连同连接在上面的端子从底盘上拆下， 然后把天线连
接器的中心部分焊接到端子
注意端子上不要使用过多焊料。
2
1
3
cushion
4
TK-3148
➀
上。
➁
。
粘接在一起。
➃
上。
37