Table of Contents
Advertisement
TK-3148
■ Removing the front panel
After removing the battery pack, knobs, and antenna,
remove the 2 screws from the back of the transceiver.
Lift the chassis away from the bottom part gently, then pull
out the chassis as shown below.
■ Connecting the PTT, MIC, SP, and SW2 cables
When connecting the PTT, MIC, SP and SW2 2-wire cables,
ensure that the color of each cable mates as shown in the
following diagram.
36
ADJUSTMENT /
PTT(WHITE) /
SW1
SW1(RED) /
PTT
GND
SW2
MIC(WHITE) /
CN303
CN304
SP(WHITE) /
GND(BLUE) /
SW2(WHITE) /
调整
■ 拆下前面板
拆下电池组、 旋钮、 天线之后， 拆下收发机背面的两个螺钉。
轻轻从底部抬起底盘，然后按下图所示拔出底盘。
■ 连接 PTT、MIC、SP 和 SW2 电缆
在连接 PTT、MIC、SP 和 SW2 双线电缆时，确保各电缆的
颜色匹配如下图所示。
MIC(BLUE) /
CN306
SP(BLUE) /
CN305
Advertisement
Table of Contents
