Locking The Rvg Sensor To The Computer; Locking A Single Rvg Sensor To The Computer - Kodak RVG 6500 IPS System User's Installation Manual

6
Acquiring an Image

Locking the RVG Sensor to the Computer

You need to lock the RVG sensor to the computer where the acquired image must appear.
Important: You can use the RVG sensor to acquire an image while
charging ONLY with the medical charger.

Locking a Single RVG Sensor to the Computer

If you have a single RVG sensor, you need to lock it only once to the computer where the acquired
image must appear.
To Lock the RVG sensor to your computer, follow these steps:
Press the remote control button of the RVG control box to turn ON the device. The blinking blue
1
light indicates the sensor attempt to connect to the WiFi access point. Wait for the blinking blue
light (A) to become solid blue. (B) The sensor is connected to the WiFi access point.
Access the Imaging Window. Click
2
You can also access the RVG Acquisition interface, doing the following:
•
Press the remote control button of the selected RVG control box, or
•
Press F2 on the computer key board.
A
B
to access the RVG Acquisition interface.
KODAK RVG 6500 System_User & Installation Guide (SM728)_Ed01 31