Troubleshooting - Smooth Fitness FX4 User Manual

31
FX4 MOTORIZED TREADMILL

TROUBLESHOOTING

Troubleshooting
NOTE: Do not touch any internal electric wires without consulting the manufacturer.
Treadmill will not start:
1. Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly grounded outlet
and the surge protector is turned on (refer to the Power Requirements section in this manual).
2. Check the circuit breaker reset switch located on the front of the treadmill. Turn the power off, wait 5 minutes then press
the rest switch.
3. Check the house electrical breaker box and the circuit breaker for the room the treadmill is located in. If it has tripped,
reset or have an electrician replace the breaker in home.
4. Have an electrician check for inadequate voltage at the outlet.
Treadmill looses power during use:
1. Check the circuit breaker reset switch located on the front of the treadmill. Turn the power off, wait 5 minutes then press
the rest switch.
If the treadmill still will not operate, please call your local EVO dealer or contact us directly at 888-800-1167.
2. Check the house electrical breaker box and the circuit breaker for the room the treadmill is located in. If it has tripped,
reset or have an electrician replace the breaker in home.
Treadmill walking belt slows during use:
1. Check to make sure the treadmill is securely plugged into an UL-listed surge protector, rated at 15 amps, with a 14-guage
cord of five feet or less and the surge protector is securely plugged into the outlet. If the treadmill still will not operate, please
call your local EVO dealer or contact us directly at 888-800-1167.
Treadmill walking belt slips or is not centered on rear roller:
Refer to the Belt Adjustment section of this manual. If you require additional assistance please call your local EVO dealer or
contact us directly at 888-800-1167.
Visit us at: www.evofitness.com