Installing The Back - Invacare Matrix MX1 User Manual

5 QUICK RELEASE DUAL MOUNT
5.9

Installing the Back

 The instructions in this section apply to both sets of
mounting hardware.
The right side is pictured in the figures in this procedure.
The mounting pin assembly A is secured to the slots B of
the clamp body C.
A
C
1. Loosen the four mounting screws securing the adjustable mounting
bracket D to the back pan E.
2. Adjust the width of the adjustable mounting bracket so that it aligns
with the mounting pin assembly on the clamp body.
3. Lift the lever F on the adjustable mounting bracket to unlock it.
4. Insert the upper and lower pins G into the notches H in the
adjustable mounting bracket.
Invacare® Matrx® MX1
INSIDE VIEW
B
E
2
D
H
5. Push down on the back pan to ensure the mounting pins are
properly seated inside the notched recess of the adjustable
mounting bracket.
6. Press the lever down to lock the back pan into place.
22
A
3
H
F
G
C
6
Part No. 1176090
G
4