Invacare Matrix MX1 User Manual page 17

Back cushion
Hide thumbs Also See for Matrix MX1:
Table of Contents

Advertisement

Available languages

Available languages

6.
Tighten the compression bar hardware E to hold the locking pins
G in place. Do not fully tighten the hardware at this time.
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw F is designed only to hold the
compression bar in place during installation. Adjusting
this screw may prevent the compression bar from
tightening properly onto the back cane.
7.
Repeat STEPS 1-6 to install the back onto the remaining band clamp.
It may be necessary to slide the angle adjustable brackets
I to allow the clamp body to properly align with the band
clamp.
Part No. 1176090
G
E
F
8.
Adjust the back shell J so it is centered between the back canes K.
9.
Tighten the eight screws L securing the angle adjustable brackets
I to the back shell.
J
I
17
4 FIXED DUAL MOUNT
I
L
K
Invacare® Matrx® MX1

Advertisement

Table of Contents
loading

Table of Contents