Canon XF705 Instruction Manual page 166

Browser Remote: Controlling the Camcorder from a Network Device
1 Live view screen
Shows the camcorder's live view image. When the live view image is not turned on, the camcorder ID will
appear here.
166
NOTES
• The live view image will not be displayed in Browser Remote in the following cases.
- While the color bars are displayed.
- When the resolution is 2340x2160, the frame rate is 59.94P or 50.00P and
Setup] > [SDI/HDMI Max Res.] is set to [3840x2160].
2 Status indicators
:
STBY, etc. :
`
STBY , REC
4
:
:
è
, etc. :
3 [LIVE VIEW] button
Touch the button to display the camcorder's live view image on the Browser Remote screen.
4 [Shot Mark] button
While recording, touch the button to add a shot mark to the clip. When the [Shot Mark] message appears,
touch [ ].
NOTES
• Depending on the Wi-Fi connection's strength, there may be delay of 0.5 seconds or more between the
frame shown when you touch the button and the frame to which the camcorder adds the shot mark.
5 Clip marks buttons
When recording, you can tag important clips by adding clip marks (A 107).
To add a clip mark: After recording a clip, touch [
a % mark to the clip. When the [OK Mark] or [CHECK Mark] message appears, touch
6 Browser Remote screen selection ([Full] user only)
Touch [v] to open the main remote recording screen, [
open the basic screen for devices with a small screen (A 172).
7 [FULL AUTO] button
To set the camcorder to full auto mode (A 43), touch [Off], select [On] and then touch [
8 Language selection
Changes the language used for controls in the [
most of the application's controls emulate physical buttons on the camcorder and appear in English only,
regardless of the language selected.
9 Key lock button
Touch the icon to lock the Browser Remote screens in order to prevent settings from being changed
inadvertently.
D
10 [ Touch Focus] button
Touch the button to unlock (enable) the touch focus mode.
Wi-Fi connection indicator. While Browser Remote is correctly connected to the camcorder, the
dots will keep turning on and off in a loop.
Recording operation (same as on the camcorder, A 46).
`
: Output recording command (A 186).
Appears during double slot recording (A 36).
Infrared recording (A 116)
Remaining battery charge (A 45)
Mark] to add an $ mark to the clip, or [
] to open the metadata screen (A 170), or [ ] to
] (metadata input) screen and for error messages. Still,
> [B " System
Mark] to add
.
].