Ip Streaming; Ip Streaming Settings - Canon XF705 Instruction Manual

IP Streaming

After connecting the camcorder to a network, you can stream the camcorder's live video and audio* over IP to a
compatible IP video decoder** connected to the network. You can use IP streaming for live broadcasts or to
send a news flash report from a location with poor network connectivity.
While IP streaming is activated, internal recording to an SD card in the camcorder is disabled but recording to an
external device is possible.
* Only 2 channels. During 4-channel audio recording, you can select which two channels to stream over IP.
**This can be a dedicated video transfer device or decoder software on a computer. For details about compatible decoders,
please visit your local Canon Web site.
Configuration of video streamed over IP
Video format*
(compression)
XF-HEVC
(H.265/HEVC compression)
XF-AVC
(MPEG-4 AVC/H.264 compression)
> [3 ! Recording/Media Setup] > [Rec Format] setting. Available streaming signal options will vary depending on
*
the recording video configuration used.
Operating modes:

IP Streaming Settings

Before you can stream video over IP, you need to configure settings related to the transfer like the protocol and
port number to use. You can also select the configuration of the streamed video.
Camcorder Settings
1 Configure an Ethernet network connection (A 159).
2 Select [IP Streaming Settings].
> [ ! Network Settings] > [IP Streaming Settings]
3 To select the video streaming configuration, select [Streaming Output Signal].
• Select the desired option and then press SET.
4 To select the audio streaming channels, select [Audio Out Channels].
• Select the desired option and then press SET.
5 Select [Protocol].
• Select the desired option and then press SET.
• If you selected [RTP+FEC], complete the error correction settings (A 174).
Options
[UDP]: This protocol prioritizes transfer speeds but does not guarantee the reliability/integrity of the data. Lost or
delayed IP packets are ignored.
[RTP]: Standard protocol for video/audio broadcasts over the Internet. Lost or delayed IP packets are ignored.
[RTP+FEC]: This setting uses the RTP protocol and adds a layer of FEC error correction so the receiving side* can
recover lost or delayed IP packets.
* A decoder compatible with FEC error correction is required.
Video
Bit rate Resolution
16 Mbps, 9 Mbps 3840x2160
9 Mbps, 4 Mbps 1920x1080
9 Mbps, 4 Mbps 1920x1080
Streaming configuration
Frame rate
59.94P, 29.97P, 50.00P,
25.00P
59.94i, 50.00i
IP Streaming
173
Audio
MPEG-2 AAC,
256 Kbps, 2 channels